Lower ignition shielding - drivers side. I wish I had these pictures to figure out how they get installed 
posted by Frank at
6:04 PM
About
This blog is to document and track the restoration of my 1973 L82 Corvette convertible
Previous
- passenger side #4 mount repaired / painted and rea...
- Patch welded and painted - drivers side
- passenger side patch
- I cut out the rust and fabricated a patch from 1/8...
- The passenger side #4 mount was pretty badly rust...
- The old bushings were pretty bad
- The #4 body mounts (in the rear wheelwell) were to...
- Body lifted a few inches
- I used my engine hoist and a corvette body lift st...
- I needed to replace the fuel lines which required ...
0 Comments:
Post a Comment
<< Home