I cut out the rust and fabricated a patch from 1/8 welding steel.I had a mobile welder come and weld the mounts back together - drivers side 
posted by Frank at
6:18 PM
About
This blog is to document and track the restoration of my 1973 L82 Corvette convertible
Previous
- The passenger side #4 mount was pretty badly rust...
- The old bushings were pretty bad
- The #4 body mounts (in the rear wheelwell) were to...
- Body lifted a few inches
- I used my engine hoist and a corvette body lift st...
- I needed to replace the fuel lines which required ...
- Ready to be painted
- All taped up and ready for cleaning and painting
- Engine compartment is degreased and powerwashed -...
- The firewall had a crack where it met the passenge...
0 Comments:
Post a Comment
<< Home