passenger side #4 mount repaired / painted and ready to go 

Patch welded and painted - drivers side 

passenger side patch  

I cut out the rust and fabricated a patch from 1/8 welding steel.I had a mobile welder come and weld the mounts back together - drivers side  

The passenger side #4 mount was pretty badly rusted  

The old bushings were pretty bad  

The #4 body mounts (in the rear wheelwell) were totally rusted. the new poly bushings were smaller than the rusted out hole 

Body lifted a few inches  

I used my engine hoist and a corvette body lift strap from Corvette Central to lift the body 6-10 inches. The orange straps are just a precaution so I don't break the body in half 

I needed to replace the fuel lines which required me to lift the body. Scope creep - the rear body mounts #4 were both rusted out and needed to be repaired before dropping the body back down